gabion cages, gabion net factory

Gabion cages are assembled from various mesh sizes of gabion meshes in accordance with ASTM A975-97. The gabion cages are divided into several partitions (twisted hexagonal metal meshes) separated by 1 meter. For the cell, in order to strengthen the strength of the gabion cage structure, steel wires with a thicker diameter are used at the edge ends of all the surface net plates. Control and guide rivers and floods, flood discharge dams and diversion dams, rock fall protection, prevent water and soil erosion, bridge protection, solid soil structure, coastal defense engineering, port engineering, retaining wall, road protection.

1. Gabion cages are produced in one molding process. Except for the cover plate, the side plate, end plate and bottom plate are inseparable. Length/width tolerance (±5%) and height tolerance (±5%). The interior is divided into independent units with partitions every 1 meter.

2. The gabion cage adopts the assembly method. The cover plate, the side plate, the end plate and the bottom plate are separately produced and assembled into a cage. Each part is wound and bound with spiral steel wire. All the side wires of the cage are made of thick wires to strengthen the strength of the gabion net. .

1. Place the gabion cages with staggered seams in place to avoid longitudinal through seams.

2. Stand up the four sides of the stone cage net box, and lock the adjacent edges with the tie line. When tying the lock, wrap the tie line around the two overlapping frame lines (when stitching the edges) or the double kinks of the frame line and the net cage The edges (when stitching the grille) are screwed tightly to avoid heavy galvanizing damage, and the pitch is not more than 50 mm.

3. When installing the gabion cage on the completed bottom net, apply the binding wire along the lower frame of the newly installed gabion cage to fix it on the gabion cage on the bottom layer, and the adjacent gabion cages on the same layer are also The tie wires should be used to fasten each other to make the gabion cages into a whole.

4. When constructing at the same level of a certain unit project, fill the pebbles after all the gabion nets are in place. In order to prevent the deformation of the gabion nets, two adjacent gabion nets (including those of the same gabion net) The height difference between adjacent cells should not be greater than 35 cm;

5. Before the gabion cage is installed, the bank slope and the ground should be properly trimmed, and the original shape of the bank slope should be maintained as much as possible, but there should be no obvious uplifts and depressions.

6. The filled pebbles are selected on the floodplain, and their compressive strength should meet the design requirements. The particle size of the pebbles should be between 8-20 cm, and the size should be reasonably matched to achieve the design requirements of the porosity and ensure the straight line of the gabion net shape.

This product is commonly used in highways, railway guardrails, side slope protection, side slope greening, mountain slopes, hanging net shotcrete, shaft protection, construction, breeding nets, zoo fences, grassland fences, hillside net cages, flood-resistant net cages, Dike fence, control and guide the direction of rivers, flood discharge dams and diversion channels, rock fall protection, bridge protection, soil consolidation structure, retaining wall, prevention of soil erosion, coastal defense projects, port projects, etc.